Manual

541/20/2012165
Page 54
IMBA-G410 ATX Motherboard
Setting Description
Short 1-2 +5 V (Default)
Short 2-3 +5VSB
Table 4-7: USB Power Select Jumper Settings
Figure 4-13: USB Power Select Jumper Location
4.5 Internal Peripheral Device Connections
This section outlines the installation of peripheral devices to the onboard connectors.
4.5.1 SATA Drive Connection
The IMBA-G410 is shipped with two SATA drive cables and one SATA drive power cable.
To connect the SATA drives to the connectors, please follow the steps below.
Step 1: Locate the connectors. The locations of the SATA drive connectors are shown
in Chapter 3.
Step 2: Insert the cable connector. Press the clip on the connector at the end of the
SATA cable and insert the cable connector into the on-board SATA drive
connector. See Figure 4-14.