Owner's manual

2010/10/262010/10/26
IMBA-G412ISA ATX Motherboard
Page 49
4.3.3 DIMM Installation
To install a DIMM, please follow the steps below and refer to 652H652H652HFigure 4-7.
Figure 4-7: DIMM Installation
Step 1: Open the DIMM socket handles. Open the two handles outwards as far as
they can. See
653H653H653HFigure 4-7.
Step 2: Align the DIMM with the socket. Align the DIMM so the notch on the memory
lines up with the notch on the memory socket. See
654H654H654HFigure 4-7.
Step 3: Insert the DIMM. Once aligned, press down until the DIMM is properly seated.
Clip the two handles into place. See
655H655H655HFigure 4-7.
Step 4: Removing a DIMM. To remove a DIMM, push both handles outward. The
memory module is ejected by a mechanism in the socket.Step 0:
4.3.4 Motherboard Installation
To install the IMBA-G412ISA motherboard into the chassis please refer to the reference
material that came with the chassis.