Owner's manual

2010/10/262010/10/26
IMBA-G412ISA ATX Motherboard
Page 53
4.4.4 CompactFlash® Setup
Jumper Label: JP2
Jumper Type:
2-pin header
Jumper Settings:
See
664H664H664HTable 4-5
Jumper Location:
See
665H665H665HFigure 4-11
The CompactFlash® slot is connected through an IDE connection. This jumper sets the
CompactFlash® card as the master or slave IDE device.
Setting Description
Short Master (Default)
Open Slave
Table 4-5: CompactFlash® Setup Jumper Settings
Figure 4-11: CompactFlash® Setup Jumper Location
4.4.5 CF Voltage Select Jumper
Jumper Label: J_CF1
Jumper Type:
3-pin header
Jumper Settings:
See
666H666H666HTable 4-6
Jumper Location:
See
667H667H667HFigure 4-12
The CF voltage select jumper sets the voltage of the CompactFlash® slot.