Manual

IMBA-XQ354 Motherboard
Page 74
Figure 5-6: Securing the Heat sink to the PCB Board
Step 5: Tighten the screws. Use a screwdriver to tighten the four screws. Tighten each
nut a few turns at a time and do not over-tighten the screws.
Step 6: Connect the fan cable. Connect the cooling kit fan cable to the fan connector
on the IMBA-XQ354. Carefully route the cable and avoid heat generating chips
and fan blades. Step 0:
5.3.3 DIMM Installation
WARNING:
Using incorrectly specified memory modules may cause permanent
damage the IMBA-XQ354. Please make sure the memory modules
comply with the recommended memory specifications.
To install a DIMM, please follow the steps below and refer to 928H928HFigure 5-7.