User's Manual

IOVU-210AD-RK39 Panel PC
Page 10
To unpack the panel PC, follow the steps below:
WARNING!
The front side LCD screen has a protective plastic cover stuck to the
screen. Only remove the plastic cover after the system
has been
properly installed. This ensures the screen is protected during the
installation process.
Step 1: Carefully cut the tape sealing the box. Only cut deep enough to break the tape.
Step 2: Open the box.
Step 3: Lift the IOVU-210AD-RK39 out of the box.
Step 4: Make sure all the components listed in the packing list are present. Step 0:
2.1 Packing List
NOTE:
If any of the components listed in the checklist below are missing, do
not proceed with the installation. Contact the IEI reseller or vendor the
IOVU-210AD-RK39
was purchased from or contact an IEI sales
representative directly by sending an email to [e-mail].
The IOVU-210AD-RK39 is shipped with the following components:
Quantity Item Image
1 IOVU-210AD-RK39 panel PC
Table 2-1: Packing List