User's Manual

IOVU-210AD-RK39 Panel PC
Page 23
NOTE:
When purchasing the arm, please ensure that it is VESA compliant and that
the arm has a 75 mm interface pad. If the mounting arm is
not VESA
compliant, it cannot be used to support the IOVU-210AD-RK39.
Step 2: Once the mounting arm has been firmly attached to the surface, lift the
IOVU-210AD-RK39 onto the interface pad of the mounting arm.
Step 3: Align the retention screw holes on the mounting arm interface with those in the
IOVU-210AD-RK39, as shown in Figure 3-9.
Figure 3-9: Arm Mounting Retention Screw Holes
Step 4: Secure the IOVU-210AD-RK39 to the interface pad by inserting four retention
screws through the bottom of the mounting arm interface pad and into the
IOVU-210AD-RK39 (Figure 3-10). Step 0: