User Manual
Table Of Contents
- 1 Introduction
- 2 Unpacking
- 3 Connectors
- 3.1 Peripheral Interface Connectors
- 3.2 Internal Peripheral Connectors
- 3.2.1 ATX Power Enable Connector
- 3.2.2 Audio Connector (10-pin)
- 3.2.3 Backlight Inverter Connector
- 3.2.4 Battery Connector
- 3.2.5 CompactFlash® Socket
- 3.2.6 Digital Input/Output (DIO) Connector
- 3.2.7 Fan Connector (+5V)
- 3.2.8 Floppy Disk Connector
- 3.2.9 Front Panel Connector (8-pin)
- 3.2.10 IDE Connector (40-pin)
- 3.2.11 Infrared Interface Connector (5-pin)
- 3.2.12 Keyboard/Mouse Connector
- 3.2.13 Parallel Port Connector
- 3.2.14 Power Connector
- 3.2.15 SATA Drive Connectors (Optional)
- 3.2.16 Serial Port Connector (RS-232/422/485)
- 3.2.17 TTL Connector
- 3.2.18 Internal USB Connectors
- 3.2.19 -VCC Power Connector
- 3.3 External Peripheral Interface Connectors
- 4 Installation
- 5 BIOS Screens
- A BIOS Menu Options
- B One Key Recovery
- C Terminology
- D Watchdog Timer
- E Hazardous Materials Disclosure
IOWA-LX-600 Half-size CPU Card
Page 90
ECP
The parallel port operates in the extended
capabilities port (ECP) mode. The ECP mode
supports bi-directional communication between the
system and the parallel port device and the
transmission rates between the two are much faster
than the SPP mode.
ECP+EPP
The parallel port is compatible with both ECP and
EPP devices.
Normal
EPP Mode Select [EPP1.7]
The Parallel Port EPP Type option is only available if the Parallel Port Mode option is
set to EPP mode. Use the EPP Mode Select option to select the parallel port mode
standard for the parallel port.
EPP1.9
EPP 1.9 is selected as the EPP standard.
EPP1.7
(Default) EPP 1.7 is se lected as the EPP standard.
ECP Mode Use DMA [3]
Use the ECP Mode Use option to select which DMA channel sh ould be used for this port.
1
The parallel port use s DMA Channel 1 in ECP mode.
3
(Default) The parallel port uses DMA Channel 3 in ECP mode.
5.5.1 IT8888 ISA Decode IO
Access the IT8888 ISA Decode configuration settings (6BIOS Menu 8) in the Integrated
Peripherals menu an d make the appropriate I/O space settings.