Instruction Manual

ITDB-100L Barcode Reader
Page 24
3.3.3 Micro USB Connector
The ITDB-100L is equipped with a Micro USB connector that allows connection to a
computer. Follow the steps below to connect the ITDB-100L to a computer by using the
supplied Micro USB cable.
Step 1: Locate the Micro USB connector. The location of the Micro USB connector is
shown in
Figure 1-3.
Step 2: Align the Micro USB connectors. Align the Micro USB connector on the Micro
USB cable with the Micro USB connector on the ITDB-100L. See
Figure 3-10.
Figure 3-10: Micro USB Connection
Step 3: Insert the Micro USB cable Micro USB connector. Once aligned, gently insert
the Micro USB cable Micro USB connector into the Micro USB connector on the
ITDB-100L.
Step 4: Connect the other end (USB Standard Type A) of the Micro USB cable to the
USB Type A receptacle of a computer. See
Figure 3-11.