User Manual

KINO-PV-D5252/D4252 Mini ITX SBC
Page 52
Before the KINO-PV-D5252/D4252 is installed in the system, the jumpers must be set in
accordance with the desired configuration. The jumpers on the KINO-PV-D5252/D4252
are listed in
829HTable 4-1.
Description Type Label
AT/ATX Power setting 3-pin wafer ATXCTL1
Clear CMOS 3-pin header J_CMOS1
CompactFlash® setting 2-pin header JCF1
LVDS1 Panel Resolution Select setting 6-pin header J2
LVDS2 Panel Resolution Select setting 6-pin header J_LCD_TYPE1
LVDS1 Voltage Select setting 6-pin header J_VLVDS1
LVDS2 Voltage Select setting 2-pin header J_VLVDS2
Serial port setting 8-pin header JP3
Table 4-1: Jumpers
4.6.1 AT/ATX Power Select Jumper Settings
Jumper Label: ATXCTL1
Jumper Type:
3-pin header (1x3)
Jumper Settings:
See Table 4-2
Jumper Location:
See Figure 4-4
The AT/ATX Power Select jumper specifies the systems power mode as AT or ATX.
AT/ATX Power Select jumper settings are shown in Table 4-2.
AT Power Select Description
Short 1 - 2 Use ATX power
Short 2 – 3 Use AT power Default
Table 4-2: AT/ATX Power Select Jumper Settings
The location of the AT/ATX Power Select jumper is shown in Figure 4-4 below.