User's Manual

MODAT-200
Page 11
The installation steps below should be followed in order.
Step 1: Unpack the device
Step 2: Check all parts are included
Step 3: Charge the MODAT-200.
Step 4: Power up the system Step 0:
2.1 Unpack the Device
WARNING!
Only remove the protective plastic cover stuck to the front screen after
installation. The plastic layer protects the screen surface during
installation process.
To unpack the MODAT-200, follow these steps:
Step 1: Cut the sealing tape. Only cut deep enough cut the tape.
Step 2: Open the box.
Step 3: Lift out the device.
Step 4: Remove all the peripheral parts from the box. Step 0: