Instruction Manual

NANO-945GSE2
Page 57
WARNING:
Disconnect the power supply power cord from its AC power source to
prevent a sudden power surge to the NANO-945GSE2.
Step 1: Locate the power cable. The power cable is shown in the packing list in
Chapter 3.
Step 2: Connect the Power Cable to the Motherboard. Connect the 4-pin (2x2) Molex
type power cable connector to the AT power connector on the motherboard. See
Figure 4-9.
Figure 4-9: Power Cable to Motherboard Connection
Step 3: Connect Power Cable to Power Supply. Connect one of the 4-pin (1x4) Molex
type power cable connectors to an AT power supply. See
Figure 4-10. Step 0: