Instruction Manual

NANO-945GSE2
Page 64
Step 3: Insert the cable connectors. Once the cable connector is properly aligned with
the 26-pin box-header connector on the NANO-945GSE2, connect the cable
connector to the on-board connector. See
Figure 4-16.
Figure 4-16: LPT Cable Connection
Step 4: Attach the LPT connector to the chassis. To secure the LPT interface
connector to the chassis please refer to the installation instructions that came
with the chassis.
Step 5: Connect LPT device. Once the LPT interface connector is connected to the
chassis, the LPT device can be connected to the LPT interface connector. See
Figure 4-17Step 0:\