Instruction Manual

NANO-945GSE2
Page 65
Figure 4-17: Connect the LPT Device
4.7.7 Dual RS-422/485 Cable
An optional RS-422/485 dual serial port connector cable is available for the
NANO-945GSE2. The dual serial port connector cable connects the serial port connectors
on the cable to the RS-422/485 serial port connectors on the NANO-945GSE2. Follow the
steps below to connect the dual serial port connector cable.
Step 1: Locate the serial port connector. The location of the RS-422/485 serial port
connector is shown in Chapter 3.
Step 2: Align the connectors. Correctly align pin 1 on the cable connector with pin 1 on
the NANO-945GSE2 COM2 serial port connector.
Step 3: Insert the cable connectors. Once the cable connector is properly aligned with
the COM2 serial port connector on the NANO-945GSE2, connect the cable
connector to the on-board connectors. See
Figure 4-18.