Instruction Manual

NANO-CV-D25502/N26002 EPIC SBC
Page 47
4.6.5 SATA Drive Connection
The NANO-CV-D25502/N26002 is shipped with a SATA drive cable. To connect the SATA
drive to the connector, please follow the steps below.
Step 1: Locate the SATA connector and the SATA power connector. The locations of
the connectors are shown in Chapter 3.
Step 2: Insert the cable connector. Insert the cable connector into the on-board SATA
drive connector and the SATA power connector. See
Figure 4-12.
Figure 4-12: SATA Drive Cable Connection
Step 3: Connect the cable to the SATA disk. Connect the connector on the other end
of the cable to the connector at the back of the SATA drive. See
Figure 4-12.
Step 4: To remove the SATA cable from the SATA connector, press the clip on the
connector at the end of the cable.