Instruction Manual

NANO-CV-D25502/N26002 EPIC SBC
Page 49
4.7 External Peripheral Interface Connection
This section describes connecting devices to the external connectors on the
NANO-CV-D25502/N26002.
4.7.1 LAN Connection
The RJ-45 connector enables connection to an external network. To connect a LAN cable
with an RJ-45 connector, please follow the instructions below.
Step 1: Locate the RJ-45 connector. The locations of the RJ-45 connectors are shown
in Chapter 3.
Step 2: Align the connectors. Align the RJ-45 connector on the LAN cable with the
RJ-45 connector on the NANO-CV-D25502/N26002. See
Figure 4-14.
Figure 4-14: LAN Connection
Step 3: Insert the LAN cable RJ-45 connector. Once aligned, gently insert the LAN
cable RJ-45 connector into the on-board RJ-45 connector.