Manual

NANO-HM650 EPIC SBC
Page 54
Figure 4-13: PCI-104 Power Select Jumper Location
4.5 Internal Peripheral Device Connections
This section outlines the installation of peripheral devices to the onboard connectors
4.5.1 AT/ATX Power Connection
Follow the instructions below to connect the NANO-HM650 to an AT or ATX power supply.
WARNING:
Disconnect the power supply power cord from its AC power source to
prevent a sudden power surge to the NANO-HM650.
Step 1: Locate the power cable. The power cable is shown in the packing list in
Chapter 3.
Step 2: Connect the Power Cable to the Motherboard. Connect the 4-pin (2x2) Molex
type power cable connector to the AT/ATX power connector on the motherboard.
See Figure 4-13.