User guide

NANO-HM651 EPIC SBC
Page 40
Before and during the installation of the NANO-HM651 DO NOT:
 Remove any of the stickers on the PCB board. These stickers are required for
warranty validation.
 Use the product before verifying all the cables and power connectors are
properly connected.
 Allow screws to come in contact with the PCB circuit, connector pins, or its
components.
4.3 SO-DIMM Installation
WARNING:
Using incorrectly specified SO-DIMM may cause permanently damage
the NANO-HM651. Please make sure the purchased SO-DIMM
complies with the memory specifications of the NANO-HM651.
SO-DIMM specifications compliant with the NANO-HM651 are listed in
the specification table of Chapter 1.
To install an SO-DIMM, please follow the steps below and refer to Figure 4-1.
Figure 4-1: SO-DIMM Installation
Step 1: Locate the SO-DIMM socket. Place the board on an anti-static mat.
Step 2: Align the SO-DIMM with the socket. Align the notch on the memory with the
notch on the memory socket.
Step 3: Insert the SO-DIMM. Push the memory in at a 20º angle. (See
Figure 4-1)