Owner manual

Table Of Contents

NANO-LX EPIC SBC

 Load Fail-Safe Defaults

Select this option to load failsafe default values for each BIOS parameter in the setup

menus. Press F6 for this operation on any page.

 Load Optimized Defaults

Select this option to load optimal default values for each BIOS parameter in the setup

menus. Press F7 for this operation on any page.

 Set Supervisor Password

By default, no supervisor password is set. To install a supervisor password, select this

field and enter the password. After this option is selected, a red dialogue box appears with

“Enter Password: ”. Type the password and press E

NTER. Retype the original password

into the “Confirm Password: ” dialogue box and press E

NTER. To disable the password,

simply press E

NTER in the “Enter Password: ” dialogue box, then press any key in the

“Password Disabled !!!” dialogue box.

 Set User Password

By default no user password is set. To install a user password, select this field and enter

the password. After this option is selected, a red dialogue box appears with “Enter

Password: ”. Type the password and press E

NTER. Retype the original password into the

“Confirm Password: ” dialogue box and press E

NTER. To disable the password, simply

press E

NTER in the “Enter Password: ” dialogue box, then press any key in the

“Password Disabled !!!” dialogue box.

 Save & Exit Setup

Select this option to save any configuration changes made and exit the BIOS menus.

 Exit Without Saving

Select this option exit the BIOS menus without saving any configuration changes.

Page 119