Manual

NANO-LX EPIC SBC
Page 86
Step 1: Locate the connector. The location of the RS-232 connector is shown in
Chapter 3.
Step 2: Insert the cable connector. Insert the connector into the serial port box header.
See
Figure 5-11. A key on the front of the cable connectors ensures the
connector can only be installed in one direction.
Figure 5-11: Single RS-232 Cable Installation
5.8.7 SATA Drive Connection
The NANO-LX is shipped with two SATA drive cables and one SATA drive power cable.
To connect the SATA drives to the connectors, please follow the steps below.
Step 3: Locate the connectors. The locations of the SATA drive connectors are shown
in Chapter 3.
Step 4: Insert the cable connector. Press the clip on the connector at the end of the
SATA cable and insert the cable connector into the onboard SATA drive
connector. See
Figure 5-12.