Owner's manual

NOVA-HM551 5.25" SBC
Page 66
Step 3: Connect the SATA power cable. Connect the SATA power connector into the
on-board SATA power connector. See
Figure 4-16.
Step 4: Connect the cable to the SATA disk. Connect the connector on the other end
of the cable to the connector at the back of the SATA drive. See
Figure 4-16.
Figure 4-16: SATA Drive Connection
4.7.5 Four Serial Port Connector
The 40-pin serial port connector connects the board connector to four DB-9 connectors.
To install, please follow the steps below.
Step 1: Locate the COM connector. The locations of the COM port connectors are
shown in Chapter 4.
Step 2: Insert the cable connector. Align the cable connector with the onboard
connector. Make sure pin 1 on the board and connector line up.