Owner's manual

PCISA-945GSE CPU Card
Page 64
Step 3: Insert the cable connectors. Once the cable connector is properly aligned with
the 26-pin box-header connector on the PCISA-945GSE, connect the cable
connector to the on-board connector. See
Figure 4-10.
Figure 4-10: LPT Cable Connection
Step 4: Attach the LPT connector to the chassis. To secure the LPT interface
connector to the chassis please refer to the installation instructions that came
with the chassis.
Step 5: Connect LPT device. Once the LPT interface connector is connected to the
chassis, the LPT device can be connected to the LPT interface connector. See
Figure 4-14Step 5:\
4.9.7 SATA Drive Connection
The PCISA-945GSE is shipped with two SATA drive cables and one SATA drive power
cable. To connect the SATA drives to the connectors, please follow the steps below.
Step 6: Locate the connectors. The locations of the SATA drive connectors are shown
in Chapter 3.