Instruction Manual
Table Of Contents
- 1 Introduction
- 2 Unpacking
- 3 Connectors
- 3.1 Peripheral Interface Connectors
- 3.2 Internal Peripheral Connectors
- 3.2.1 12V / 5V Power Connector
- 3.2.2 ATX Power Supply Enable Connector
- 3.2.3 Audio Kit Connector
- 3.2.4 Battery Connector
- 3.2.5 CompactFlash® Connector
- 3.2.6 Fan Connector
- 3.2.7 Digital I/O Connector
- 3.2.8 Keyboard/Mouse Connector
- 3.2.9 LAN Connector
- 3.2.10 LCD Inverter Connector
- 3.2.11 LED and +5V Output Connector
- 3.2.12 PCI-104 Connector
- 3.2.13 Power Button Connector
- 3.2.14 Reset Button Connector
- 3.2.15 RS-232 Serial Port Connectors
- 3.2.16 RS-422/485 Serial Port Connector
- 3.2.17 LVDS LCD Connector
- 3.2.18 SATA Drive Connector
- 3.2.19 SPI Flash Connector
- 3.2.20 USB Connector
- 3.2.21 VGA Connector
- 4 Installation
- 5 BIOS
- A BIOS Options
- B Terminology
- C Watchdog Timer
- D Hazardous Materials Disclosure
PM-945GSE-N270 User Manual
Page 111
Below is a list of BIOS configuration options in the BIOS chapter.
System Overview .................................................................................................................76
System Time [xx:xx:xx].......................................................................................................77
System Date [xx/xx/xx]........................................................................................................77
ATA/IDE Configurations [Compatible]...............................................................................79
Legacy IDE Channels [PATA Pri, SATA Sec]....................................................................80
IDE Master and IDE Slave....................................................................................................80
Hard Disk Write Protect [Disabled] ....................................................................................80
Auto-Detected Drive Parameters........................................................................................81
Type [Auto] ...........................................................................................................................82
LBA/Large Mode [Auto].......................................................................................................82
Block (Multi Sector Transfer) [Auto]..................................................................................83
PIO Mode [Auto]...................................................................................................................83
DMA Mode [Auto].................................................................................................................84
S.M.A.R.T [Auto]...................................................................................................................85
32Bit Data Transfer [Enabled].............................................................................................85
Serial Port1 Address [3F8]..................................................................................................86
Serial Port1 IRQ [4] ..............................................................................................................86
Serial Port2 Address [2F8]..................................................................................................86
Serial Port2 IRQ [3] ..............................................................................................................87
Serial Port3 Address [3E8]..................................................................................................87
Select RS232 or RS485/RS422 [RS/232] ............................................................................87
Serial Port3 IRQ [4] ..............................................................................................................87
Serial Port4 Address [2E8]..................................................................................................88
Serial Port4 IRQ [3] ..............................................................................................................88
Hardware Health Monitoring...............................................................................................89
Current Jumper Setting [AT Power]...................................................................................90
Remote Access [Disabled]..................................................................................................91
Serial Port r [1] .....................................................................................................................91
Base Address, IRQ [3F8h,4]................................................................................................92
Serial Port Mode [115200 8,n,1]..........................................................................................92
Redirection After BIOS POST [Always] .............................................................................92
Terminal Type [ANSI]...........................................................................................................93
USB Configuration...............................................................................................................94