Owner's manual

66
IEI
®
Technology, Corp.
3.4 Onboard Jumpers
NOTE:
A jumper is a metal bridge that is used to
close an electrical circuit. It consists of
two metal pins and a small metal clip
(often protected by a plastic cover) that
slides over the pins to connect them. To
CLOSE/SHORT a jumper means
connecting the pins of the jumper with
the plastic clip and to OPEN a jumper
means removing the plastic clip from a
jumper.
The ROCKY-3786EV CPU Board has four onboard jumpers. See
Table 3-3
.
Figure 3-26: Jumper Locations
Figure 3-25 Jumper