User Manual
Table Of Contents
- WAFER-945GSE2
- 1 Introduction
- 2 Packing List
- 3 Connectors
- 3.1 Peripheral Interface Connectors
- 3.2 Internal Peripheral Connectors
- 3.2.1 ATX Power Connector
- 3.2.2 ATX Power Supply Enable Connector
- 3.2.3 Audio Connector (10-pin)
- 3.2.4 Backlight Inverter Connector
- 3.2.5 Battery Connector
- 3.2.6 CompactFlash® Socket
- 3.2.7 Digital Input/Output (DIO) Connector
- 3.2.8 Fan Connector (+12V, 3-pin)
- 3.2.9 Keyboard/Mouse Connector
- 3.2.10 LED Connector
- 3.2.11 LVDS LCD Connector
- 3.2.12 PC/104 Connector
- 3.2.13 PC/104 Power Input Connector
- 3.2.14 Power Button Connector
- 3.2.15 Reset Button Connector
- 3.2.16 SATA Drive Connectors
- 3.2.17 Serial Port Connector, RS-232/422/485
- 3.2.18 SPI Flash Connector
- 3.2.19 USB Connectors (Internal)
- 3.3 External Peripheral Interface Connector Panel
- 4 Installation
- 5 BIOS
- 6 Software Drivers
- A BIOS Options
- B One Key Recovery
- C Terminology
- D Digital I/O Interface
- E Watchdog Timer
- F Hazardous Materials Disclosure
WAFER-945GSE2 3.5" Motherboard
Page 119
Below is a list of BIOS configuration options in the BIOS chapter.
System Overview .................................................................................................................64
System Time [xx:xx:xx].......................................................................................................65
System Date [xx/xx/xx]........................................................................................................65
Hyper-Threading Technology [Enabled] ...........................................................................66
ATA/IDE Configuration [Compatible].................................................................................67
Legacy IDE Channels [SATA Pri, PATA Sec]....................................................................68
IDE Master and IDE Slave....................................................................................................68
Auto-Detected Drive Parameters........................................................................................69
Type [Auto]...........................................................................................................................70
LBA/Large Mode [Auto].......................................................................................................70
Block (Multi Sector Transfer) [Auto]..................................................................................71
PIO Mode [Auto]...................................................................................................................71
DMA Mode [Auto].................................................................................................................71
S.M.A.R.T [Auto]...................................................................................................................73
32Bit Data Transfer [Enabled].............................................................................................73
Serial Port1 Address [3F8/IRQ4] ........................................................................................74
Serial Port2 Address [2F8/IRQ3] ........................................................................................74
CPU FAN Mode Setting [Full On mode].............................................................................75
CPU Temperature Limit of Off [000]...................................................................................76
CPU Temperature Limit of On [020]...................................................................................76
CPU Fan Start PWM [070]....................................................................................................77
Slope PWM [0.5 PWM] .........................................................................................................77
Select AT/ATX Power [By HARDWARE]............................................................................79
Suspend mode [S1 (POS)] ..................................................................................................79
Restore on AC Power Loss [Last State]............................................................................80
Power Button Mode [On/Off]...............................................................................................81
Resume on Keyboard/Mouse [Disabled]...........................................................................81
Resume on Ring [Disabled] ................................................................................................81
Resume on PCI-Express WAKE# [Enabled]......................................................................81
Resume On RTC Alarm [Disabled].....................................................................................82
Remote Access [Disabled]..................................................................................................83
Serial port number [COM1] .................................................................................................83
Base Address, IRQ [3F8h,4]................................................................................................84