User Manual
Table Of Contents
- WAFER-945GSE2
- 1 Introduction
- 2 Packing List
- 3 Connectors
- 3.1 Peripheral Interface Connectors
- 3.2 Internal Peripheral Connectors
- 3.2.1 ATX Power Connector
- 3.2.2 ATX Power Supply Enable Connector
- 3.2.3 Audio Connector (10-pin)
- 3.2.4 Backlight Inverter Connector
- 3.2.5 Battery Connector
- 3.2.6 CompactFlash® Socket
- 3.2.7 Digital Input/Output (DIO) Connector
- 3.2.8 Fan Connector (+12V, 3-pin)
- 3.2.9 Keyboard/Mouse Connector
- 3.2.10 LED Connector
- 3.2.11 LVDS LCD Connector
- 3.2.12 PC/104 Connector
- 3.2.13 PC/104 Power Input Connector
- 3.2.14 Power Button Connector
- 3.2.15 Reset Button Connector
- 3.2.16 SATA Drive Connectors
- 3.2.17 Serial Port Connector, RS-232/422/485
- 3.2.18 SPI Flash Connector
- 3.2.19 USB Connectors (Internal)
- 3.3 External Peripheral Interface Connector Panel
- 4 Installation
- 5 BIOS
- 6 Software Drivers
- A BIOS Options
- B One Key Recovery
- C Terminology
- D Digital I/O Interface
- E Watchdog Timer
- F Hazardous Materials Disclosure
WAFER-945GSE2 3.5" Motherboard
Page 4
The WAFER-945GSE2 has the following connectors on-board:
1 x ATX power connector
1 x ATX enable connector
1 x Audio connector
1 x Backlight inverter connector
1 x Battery connector
1 x CompactFlash® socket
1 x Digital input/output (DIO) connector
1 x Fan connector
1 x Keyboard and mouse connector
1 x LED connector
1 x LVDS connector
1 x PC/104 ISA connector
1 x Power button connector
1 x Reset button connector
1 x RS-232/422/485 serial port connector
2 x Serial ATA (SATA) connectors
1 x SPI flash connector
2 x USB 2.0 connectors (supports four USB 2.0 devices)
The WAFER-945GSE2 has the following external peripheral interface connectors on the
board rear panel.
2 x Ethernet connectors
1 x RS-232 serial port connector
2 x USB connectors
1 x VGA connector
The WAFER-945GSE2 has the following on-board jumpers:
AT/ATX power mode setting
CF card setting
Clear CMOS setup
COM2 port mode setting
LVDS1 voltage selection