User Manual
Table Of Contents
- WAFER-945GSE2
- 1 Introduction
- 2 Packing List
- 3 Connectors
- 3.1 Peripheral Interface Connectors
- 3.2 Internal Peripheral Connectors
- 3.2.1 ATX Power Connector
- 3.2.2 ATX Power Supply Enable Connector
- 3.2.3 Audio Connector (10-pin)
- 3.2.4 Backlight Inverter Connector
- 3.2.5 Battery Connector
- 3.2.6 CompactFlash® Socket
- 3.2.7 Digital Input/Output (DIO) Connector
- 3.2.8 Fan Connector (+12V, 3-pin)
- 3.2.9 Keyboard/Mouse Connector
- 3.2.10 LED Connector
- 3.2.11 LVDS LCD Connector
- 3.2.12 PC/104 Connector
- 3.2.13 PC/104 Power Input Connector
- 3.2.14 Power Button Connector
- 3.2.15 Reset Button Connector
- 3.2.16 SATA Drive Connectors
- 3.2.17 Serial Port Connector, RS-232/422/485
- 3.2.18 SPI Flash Connector
- 3.2.19 USB Connectors (Internal)
- 3.3 External Peripheral Interface Connector Panel
- 4 Installation
- 5 BIOS
- 6 Software Drivers
- A BIOS Options
- B One Key Recovery
- C Terminology
- D Digital I/O Interface
- E Watchdog Timer
- F Hazardous Materials Disclosure
WAFER-945GSE2 3.5" Motherboard
Page 18
Pin Description
1 +12V
2 GND
3 GND
4 +5V
Table 3-3: ATX Power Connector Pinouts
3.2.2 ATX Power Supply Enable Connector
CN Label: ATXCTL1
CN Type:
3-pin wafer
CN Location:
See
Figure 3-4
CN Pinouts:
See
Table 3-4
The ATX power supply enable connector enables the WAFER-945GSE2 to be connected
to an ATX power supply. In default mode, the WAFER-945GSE2 can only use an AT
power supply. To enable an ATX power supply, the AT Power Select jumper must also be
configured. Please refer to Chapter 4 for more details.
Figure 3-4: ATX Power Supply Enable Connector Location
Pin Description
1 +5V Standby