User Manual

WAFER-945GSELVDS2
Page 47
Before the WAFER-945GSELVDS2 is installed in the system, the jumpers must be set in
accordance with the desired configuration. The jumpers on the WAFER-945GSELVDS2
are listed in
Table 4-1.
Description Label Type
AT Power Mode Setting ATXCTL1 2-pin header
Audio Power Source JP2 3-pin header
CF Card Setting JCF1 2-pin header
Clear CMOS J_CMOS1 3-pin header
COM2 Mode Setting JP1 6-pin header
LVDS1 Panel Resolution J_LCD_TYPE1 8-pin header
LVDS1 voltage selection J_VLVDS1 3-pin header
LVDS2 voltage selection J_VLVDS2 3-pin header
Table 4-1: Jumpers
4.6.1 AT Power Select Jumper Settings
NOTE:
The AT Power Select Jumper is the same as the ATX Enable
connector.
Jumper Label: ATXCTL1
Jumper Type:
3-pin header
Jumper Settings:
See
Table 4-2
Jumper Location:
See
Figure 4-3
Sets the system to use AT or ATX power. When set to ATX power, the power switch cable
must be connected to this jumper.
Pin Description
2-3 Use AT power