User Manual

WAFER-945GSELVDS2
Page 51
Pin Description
1-2 Keep CMOS Setup
2-3 Clear CMOS Setup
Table 4-5: Clear CMOS Jumper Settings
The location of the clear CMOS jumper is shown in Figure 4-6 below.
Figure 4-6: Clear CMOS Jumper
4.6.5 COM2 Mode Selection
Jumper Label: JP1
Jumper Type:
8-pin header
Jumper Settings:
See
Table 4-6
Jumper Location:
See
Figure 4-7
The COM 2 Function Select jumper sets the communication protocol used by the second
serial communications port (COM 2) as RS-232, RS-422 or RS-485. The COM 2 Function
Select settings are shown in
Table 4-6.
Pin Description
1-2 RS-232
3-4 RS-422
5-6 RS-485
5-6 & 7-8 RS-485 with RTS control
Table 4-6: COM 2 Function Select Jumper Settings
The COM 2 Function Select jumper location is shown in Figure 4-7.