User Manual

WAFER-945GSELVDS2
Page 59
Figure 4-13: SATA Power Drive Connection
4.8.3 RS-232 Cable Connection
The dual RS-232 cable consists of two connectors attached to two independent cables.
Each cable is then attached to a D-sub 9-pin male connector. To install the dual RS-232
cable, please follow the steps below.
Step 1: Locate the connectors. The locations of the RS-232 connectors are shown in
Chapter 3.
Step 2: Insert the cable connectors. Insert one connector into each serial port box
headers. See Figure 5-13. A key on the front of the cable connectors ensures
the connector can only be installed in one direction.