User's Manual

CNR-CPO-8500T Patient Observer
Page 22
Step 2: Align the screw holes with the mounting bracket of the stand.
Step 3: To secure the CNR-CPO-8500T to the bracket, insert the retention screws
(M4*10) came with the stand into the screw holes and tighten them.Step 0:
3.6 Powering On the System
WARNING:
To avoid risk of electric shock, this equipment must only be connected
to supply mains with protective earth.
To power on the system, follow the steps below:
Step 1: Follow the procedure described in Section 3.4 to install the power adapter, and
connect the power jack.
Step 2: Connect the other end of the power cord to a power source.
Press the power button on the I/O panel of the CNR-CPO-8500T
(Figure 3-9). The power LED on the power button lights up in blue (Figure
3-9). Step 0:
Figure 3-9: Power Button