User's Manual

TRN-TABLET3
Page 14
§ Anti-static Discharge: If a user open the rear panel of the TRN-TABLET3, to
configure the jumpers or plug in added peripheral devices, ground themselves
first and wear and anti-static wristband.
3.4 Installing and Charging the Battery Pack
CAUTION:
§ Danger of explosion if battery is incorrectly replaced. Replace only with the
same or equivalent type recommended by the manufacturer.
§ Disposal of a battery into fire or a hot oven, or mechanically crushing or
cutting of a battery, that can result in an explosion.
§ Leaving a battery in an extremely high temperature surrounding environment
that can result in an explosion or the leakage of flammable liquid or gas.
§ A battery subjected to extremely low air pressure that may result in an
explosion or the leakage of flammable liquid or gas.
To install and charge the battery pack, please follow the steps below.
Step 1: Adjust the stand to a position that allows the installation of the battery pack
(Figure 3-1).
Figure 3-1: Adjusting the 2-in-1 Stand Kit
PDF created with pdfFactory Pro trial version www.pdffactory.com