User's Manual

FCC NOTICE for IER 400 Optional RF Module

NOTICE

(U.S.A. only)

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions:

1. this device may not cause harmful interference,

2. this device must accept any interference received, including interference that may cause

undesired operation.

In accordance with FCC requirements, changes or modifications not expressly approved by IER

could void the user's authority to operate this product.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates,

uses and can radiate radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

- Consult the dealer or an experienced radio/TV technician for help.

Note: This device complies with FCC RF radiation exposure limits set forth for an uncontrolled

environment. The antenna used for this transmitter must be installed to provide a

separation distance of at least 20 cm (7.9 inches) from all persons and must not be

co-located or operating in conjunction with any other antenna or transmitter.

The certification labels are located at the rear of the printer:

IER 400

RF - FCC NOTICE

Ce document est la propriété d'IER et ne doit pas être reproduit ou communiqué sans autorisation écrite

This document is the property of IER and may not be reproduced or communicated without prior written authorization

Page 1

NC4F03A Rev. 2

Mar. 27, 2009

PAGE 1
IER 400 RF - FCC NOTICE FCC NOTICE for IER 400 Optional RF Module NOTICE (U.S.A. only) This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. this device may not cause harmful interference, 2. this device must accept any interference received, including interference that may cause undesired operation. In accordance with FCC requirements, changes or modifications not expressly approved by IER could void the user's authority to operate this product.