Safety Information

www.tuv.com
Page 18 of 59
Report No.: 50261218 001
IEC 60950-1
Clause
Requirement + Test
Result - Remark
Verdict
TRF No. IEC60950_1G
2.10.5.8
Non-separable thin sheet material
Not such material
N/A
2.10.5.9
Thin sheet material – standard test procedure
N/A
Electric strength test
¾
2.10.5.10
Thin sheet material – alternative test procedure
(see appended table 2.10.5)
P
Electric strength test
(see appended table 5.2)
¾
2.10.5.11
Insulation in wound components
Approved triple insulated wire
used in T1.
P
2.10.5.12
Wire in wound components
P
Working voltage ............................................. :
P
a) Basic insulation not under stress ................... :
N/A
b) Basic, supplementary, reinforced insulation ..... :
Wire complies to Annex U,
three layers insulation.
P
c) Compliance with Annex U ............................. :
P
Two wires in contact inside wound component;
angle between 45
° and 90°
.............................. :
Physical separation provided
by insulating tube.
P
2.10.5.13
Wire with solvent-based enamel in wound
components
No such construction.
N/A
Electric strength test
¾
Routine test
N/A
2.10.5.14
Additional insulation in wound components
No such construction.
N/A
Working voltage ............................................. :
N/A
- Basic insulation not under stress ..................... :
N/A
- Supplementary, reinforced insulation ............... :
N/A
2.10.6
Construction of printed boards
See below.
P
2.10.6.1
Uncoated printed boards
(see appended table 2.10.3
and 2.10.4)
P
2.10.6.2
Coated printed boards
No coated printed boards.
N/A
2.10.6.3
Insulation between conductors on the same inner
surface of a printed board
No multi-layer PCBs provided.
N/A
2.10.6.4
Insulation between conductors on different layers
of a printed board
No multi-layer PCBs provided.
N/A
Distance through insulation
N/A
Number of insulation layers (pcs) ....................... :
Single layer PCB
N/A
2.10.7
Component external terminations
(see appended table 2.10.3
and 2.10.4)
P
2.10.8
Tests on coated printed boards and coated
components
No such boards and
components
N/A
2.10.8.1
Sample preparation and preliminary inspection
N/A