Safety Information

www.tuv.com
Page 56 of 59
Report No.: 50261218 001
National Differences
Clause
Requirement + Test
Result - Remark
Verdict
USA National Differences
Minimum cord length is 1.5 m, with certain
constructions such as external power supplies
allowed to consider both input and output cord
lengths into the requirement
N/A
Flexible power supply cords are compatible with
Article 400 of the NEC, and Tables 11 and 12 of the
CEC
N/A
3.2.9
Permanently connected equipment has a suitable
wiring compartment and wire bending space
Pluggable equipment type A.
N/A
3.3
Wiring terminals and associated spacings for field
wiring connections comply with CSA C22.2 No. 0
N/A
3.3.3
Wire binding screws are not attached with
conductors larger than 10 AWG (5.3 mm2)
No wiring terminals.
N/A
3.3.4
Terminals for permanent wiring, including protective
earthing terminals, are suitable for Canadian/US
wire gauge sizes
, are
Pluggable equipment type A.
N/A
- rated 125 per cent of the equipment rating, and
N/A
- are specially marked when specified (1.7.7)
N/A
3.3.5
Revise first column of Table 3E to “Smaller of the
RATED CURRENT
of the equipment or the
PROTECTIVE
CURRENT RATING of the circuit under consideration”
N/A
3.4.2
Motor control devices are provided for
cord
-connected equipment with a motor if the
equipment is rated more than 12 A,
Equipment is not such a
device.
N/A
- or if the motor has a nominal voltage rating greater
than 120 V
N/A
- or is rated more than 1/3 hp (locked rotor current
over 43 A)
N/A
3.4.8
Vertically-mounted disconnect switches and circuit
breakers have the "on" position indicated by the
handle in the up position
No such switches or
breakers.
N/A
3.4.11
For computer room applications, equipment with
battery systems capable of supplying 750 VA for five
minutes have a battery disconnect means that may
be connected to the computer room remote power-
off circuit
Not such an application.
N/A
4.3.12
The maximum quantity of flammable liquid stored in
equipment complies with NFPA 30
No liquids provided.
N/A
4.3.13.5.1
Equipment with lasers meets the U.S. Code of
Federal Regulations 21 CFR 1040 (and the
Canadian Radiation Emitting Devices
Act, REDR
C1370).
No laser provided.
N/A