User's Manual
5
ii) Analogue volume control
The analogue volume control in the NEO iDSD is superior to any digital volume control. When set to
'Variable', it can be used to control the headphone or the pre-amplier volume. If the mode is set to
'Fixed', the volume control is bypassed.
The NEO iDSD uses ONLY a pure analogue volume control.Note:
iii) Mute
Press the rotary knob to mute. To unmute, press it again or turn the rotary knob.
iv) Brightness
Press and hold the knob (3 seconds) to enter brightness selection. Rotate the knob to cycle through
the three brightness modes and press to accept.
With the 'high' and 'low' brightness modes, the OLED will remain on. With the brightness mode 'off ', if no operation is performed, the Note:
OLED will go to sleep after three seconds.
3. Input channel selector/Bluetooth pairing
This button cycles through 4 inputs:
The NEO iDSD receives Bluetooth signals via aptX, aptX HD, aptX Adaptive, aptX LL, LDAC, LHDC/HWA, AAC and SBC.
Coaxial Optical USB Bluetooth