Operating Instructions

EIO344
Bluetooth Mesh adapter
10
7 Parameter setting
The parameters of this unit can be set via 2 interfaces. You can use IO-Link or Bluetooth to read
information and make changes. Assigned information and changes are possible for each interface.
For IO-Link, connect the M12 connector to a hardware for parameter setting. The connection is
established via Bluetooth with an app.
The parameter setting can be carried out with or without a sensor connected.
Information on suitable parameter setting software at www.ifm.com.
7.1 Parameter setting via IO-Link using a PC:
► Connect the Bluetooth Mesh adapter to the PC via the USB interface using the M12 connector:
Fig. 5: Parameter setting with a PC
► If the device is not detected, update the device catalogue for the parameter setting
software via the internet.
► Change the parameter settings in the software.
► Transfer the parameter settings to the device.
7.2 Parameter setting by means of a mobile device via Bluetooth
► Power the Bluetooth Mesh adapter
► The Bluetooth Mesh adapter is searched for and connected via an app
Fig. 6: Parameter setting with a mobile device
► If the device is not detected, update the device catalogue for the parameter setting
software via the internet.
► Change the parameter settings in the software.
► Transfer the parameter settings to the device.
► If a sensor is connected, it can also be reached via Bluetooth.