Users Manual Part 2
Table Of Contents
- Contents
- 1 Preliminary note
- 2 Safety instructions
- 3 Intended use
- 4 Items supplied
- 5 Function
- 6 Mounting
- 7 Electrical connection
- 8 Parameter setting
- 9 Operation
- 10 Troubleshooting
- 10.1 Troubleshooting incorrect level readings
- 10.1.1 Level too high / too low
- 10.1.2 Measured value is stuck
- 10.1.3 Measured value drops when level close to antenna
- 10.1.4 Measured value fluctuates
- 10.1.5 Measured value is occasionally unstable
- 10.1.6 Lagging of measured value during rapid level changes
- 10.1.7 Measured value correct at 0% (4 mA) but incorrect at 100% (20 mA)
- 10.1.8 Incorrect measured value when level is above 50%
- 10.1.9 Measured value drops to zero close to tank bottom
- 10.1.10 Level measurement is lost in an empty tank
- 10.1.11 Alert mode when level close to tank bottom
- 10.1 Troubleshooting incorrect level readings
- 11 Maintenance, repair and disposal
- 12 Factory setting
- 13 Appendix
LW2720 Electronic level sensor
20
CAUTION
During the welding operation, the adapter and the welding aid can increase in temperature
to over 65°C (149°F).
w Risk of burns
u Let the components of the welding aid and weld-in adapter cool down before removal.
u Hand-tighten the weld-in adapter on the welding aid.
u Insert the clamping bolt through welding aid opening.
u Mount the counter plate.
16 mm
u Hand-tighten the nut.
Weld the weld-in adapter to the tank: