Specifications

88
IGEL Technology GmbH IGEL Zero RFX 5.02.100
12. Firmware Customization
Configure the firmware to create your own personal workstation.
12.1. Custom Application
Applications which were loaded onto a customer partition for example can be launched via the Application
Launcher or an icon on the desktop once they have been defined as own applications. In order for this to
be possible, a command to call up the application must be entered under Settings.
12.2. Custom Commands
Custom commands can be mounted at various points in time during the system start.
Basic commands run once during the boot procedure.
The commands are executed at the following times:
Initialization
Not all drivers loaded, not all devices available
Network scripts not started, network not available
Partitions available except firefox profile, scim data, ncp data,
custom partition
Session Early
Not all driver loaded, not all device available
Network scripts started, network not available
Partitions available except firefox profile, scim data, ncp data,
custom partition
Sessions not configured
Session Final
All drivers loaded, all devices available
Network available
Partitions available except custom partition
System daemons not started (CUPS, ThinPrint etc.)
UMS-configuration loaded but not effective
Final
All partitions available
All system daemons started
UMS-configuration effective
Network commands run each time the relevant interface starts (standard eth0). The interface can be
defined by using the environment variable $INTERFACE (eth0, eth1, wlan0).
The commands are executed at the following times: