Quick Guide

QG-WE02-V1.1-1213-EN
16
WiFi Kit Quick Guide
(j) Re- log on this setting page to Status interface after the Web server restart, and check the network connection status
of the data logger.
Notice: After network setting is complete, the Wireless STA mode should be enabled and relative information of your
router will display on the interface automatically. Besides the Remote server A should be pingable as the picture
described.
II. Connection via Ethernet
1. Connect the data logger to the router via Ethernet port with network cable. Make sure that your computer and the
data logger are connected within the same local area network.
2. Reset the data logger.
Press the reset button with a needle or open paper clip and hold for a while when the 4 LEDs should be the same as
before. Reset is successful when 3 LEDs, except POWER, turn off.