AIR COOLER WITH LED DISPLAY Model Number: IG9703 INSTRUCTIONS FOR USE Thank you for purchasing this product.
Trouble with Cooler? … your Air Try our troubleshooting guide on page 8. If that does not solve the issue contact us … Tel: 01473 271 272 Email: info@igenix.co.uk Fax: 01473 270 733 Website: www.igenix.co.uk Postal Address: Customer Service Department Pik-a-Pak Electrical Distributors 38 Bluestem Road, Ransomes Europark, Ipswich, IP3 9RR When writing to or emailing us to report a fault please ensure you attach a copy of your proof of purchase.
SAFETY INSTRUCTIONS Important: This appliance is not intended for use by persons including children with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliances by a person responsible for their safety. 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. 16. 17. 18. 19. 20. 21. 22. 23. 24. 25. 26. 27. Read these instructions before use. Use the specified power supply.
IG9703 – Air Cooler with LED display Installation & use 1. Open the packaging and take out the air cooler. 2. Connect the wheels to the base. 3. Pull out the water tank from the body about 1/3 of the way, and pour water into the tank. If you want to remove the water tank only do so when the power has been switched off for a minimum of 2 minutes. Attention: Pay attention to the water line when filling the tank. The water must not be higher than the “MAX” water line.
IG9703 – Control Panel at a Glance Buttons: ON/OFF Setting timer Setting mode Setting fan speed Oscillation Humidification Indicator lights: ON/OFF 1 hour timer Normal mode Low fan speed 2-hour timer 4-hour timer Natural mode Sleep mode Medium fan speed High fan speed Oscillation Humidification (PLEASE NOTE: This unit will only operate as a humidifier in rooms with a high ambient temperature. Use water at room temperature.
4. Setting Mode key: When plugged in the air cooler will default to Normal Mode; If the key is pressed continuously, the air speed will switch in the following manner: Normal Natural Sleep 5. Fan Speed key: the start cooling fan is in high-level running condition; if the key is pressed continuously, the air speed will switch in the following manner: Low Medium High 6. Timer key: When the air cooler is operating press the Timer key. The timer can be set to operate continuously from between 1 – 7 hours.
Cleaning and Maintenance Unplug the power cord, first remove the Dust Filter. With a mild detergent and a soft brush, scrub the honeycomb filter, clean with clear water and dry, and then replace it to the unit. (Picture 1) After cleaning the Dust filter, remove the Honeycomb filter. With a mild detergent and a soft brush, scrub the honeycomb filter, clean with clear water and dry, and then replace it to the unit. (Picture 2~4) Unplug the power cord, and then remove the water tank.
Troubleshooting Trouble No power Possible Reason 1. power cord is unconnected Solution 1. Connect the power cord No dust elimination 2. honeycomb filter support is not installed correctly 1. The honeycomb filter is blocked. 2. Install the honeycomb filter correctly. 1. Pull down the honeycomb filter and clean it. 2. Remove the foreign matter 2.
Disposal Information Disposal of old electrical appliances The European Directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE), requires that old household electrical appliances must not be disposed of in normal unsorted municipal waste. Old appliances must be collected separately in order to optimise the recovery and recycling of the materials they contain and reduce the impact on human health and the environment.
