Igloohome Smart Padlock Model: IGP1 1. Dimensions and weight Body Thickness 32mm Body Length 70mm Body Width 55mm Shackle Thickness 9mm Vertical Clearance 26mm Horizontal Clearance 24mm Estimated product weight 450 g 2.
3. Packaging Content T27 TORX screwdriver CR2 battery Quick Start Guide (Link to e‐manual) 4. Material Shackle and Locking Mechanism: Hardened Steel Casing: Zinc Alloy 9V Battery cover – Rubber Buttons: Metal 5. Environmental and Reliability Operating Temperature: ‐25 to 55 Degree Celsius Storage Temperature: ‐40 to 70 Degree Celsius Operating Humidity: 0 to 95% Relative Humidity (Rh) Dust and Water Resistance: Product must pass IP66 certification 6.
OPEN CLOSED 8. Buttons and LED 12 Buttons (4 x 3) Status Indicator: Red, Green, Blue Keypad LED 9.
Security Mode deactivated Low Battery Alert Relock Reminder Alert Factory Reset Power Up 2 long beeps D‐C‐B beeps when keypad woken up and Breathing Red LED Red flash twice and quick beep twice repeatedly D‐C‐B‐A beeps 2 slow beeps then 2 quick beeps 10.Masking PIN Maximum = 16 digits including masking pin Product will allow up to 8 masking pins before the actual PIN code (8 digits). Product will allow up to 9 masking pins before the actual PIN code (7 digits).
User can change configuration via accessing a retaining pin after removing battery cover When in retained shackle configuration, User is able to pull the shackle up but shackle still remain in body. User is unable to remove the shackle as internal mechanism is holding the shackle. When Padlock is unlocked, it should not be too hard to open the padlock. When in removable shackle configuration, User is able to pull the whole shackle out as internal mechanism is not holding the shackle.
Unpaired product can be unlocked with Factory Pin code of 1234567890 (to test all buttons) followed by the Unlock Icon. Hard Reset can be performed only when padlock is unlocked state 17.Connectivity Bluetooth 4.2 – Bluetooth Low Energy (BLE) 18.Volume Control Volume can be changed via Bluetooth 10 levels 19.Keypad LED Toggle Keypad LED can be switched on or off via Bluetooth By default, it is switched on 20.
21.Relock Reminder Alert Relock Reminder Alert will be triggered if the lock is not locked within a period of time (user‐defined) User is able to Enable and disable Relock Reminder Alert via BT User is able to configure 10 seconds to 10 minutes 22.
FCC Warning Statement Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
