Operation Manual

17
Close the dishwasher door and turn on
the water tap.
1.
Press the ON/OFF button to switch on the
dishwasher. Select the programme required
by
turning the programme selector knob
.
The corresponding indicator lamp will
illuminate.
If required,
select any additional functions.
2.
Press the
Start
button to start the selected
wash programme. The
Start
indicator lamp
will illuminate. Once set, the programmed data
cannot be altered by turning the programme
selector knob or pressing the buttons.
Note:
Once the
Start
button has been pressed,
the dishwasher memorises all the programmes
selected. The selected programmes are also
saved in the event of power failure.
3.
To change the programme selected, press
the
Start
button for about 5 seconds until the
Start
indicator lamp switches off. Select a
new programme using the
programme
selector knob
and press the
Start
button.
The
End
indicator lamp (if fitted) illuminates
briefly and the
Start
indicator lamp switches
off to indicate the end of the programme.
4.
Turn the programme selector knob
counter
clockwise to the “0” position to switch off the
dishwasher
(only after the
End
indicator lamp
has illuminated briefly or the
Start
indicator
lamp has switched off). All the indicator
lamps switch off.
Note:
If the dishwasher is switched off
during a wash programme, when switched
on again the dishwasher resumes the wash
cycle from where it was interrupted.
Open the door and unload first the lower rack
and then the upper one.
HOW TO USE THE DISHWASHER
1
2
3
4