Operation Manual

11
• Make sure the appliance is installed and
connected to the electricity supply by a
qualified technician in accordance with
the manufacturer’s instructions and in
compliance with local regulations.
• The installer is responsible for the correct
electrical connection of the appliance and
the observance of the relative safety
prescriptions.
• The appliance must be connected to the
electricity supply by means of an all-pole
disconnect switch with minimum contact
gap of 3 mm.
• The appliance must be earthed by law.
• Do not use multiple plug adapters or
extension leads.
• After the appliance has been installed, the
electrical components must be inaccessible.
• No liability for damage or injury to
persons or property will be accepted from
non-observance of these requirements.
CONNECTION AND INSTALLATION
If the cooktop terminals do not correspond to the
connection and colour indications on the
cooktop/oven connection plate located at the top
of the oven, request the adaptor kit,
code AMC 874, from the After-sales Service.
1. Install the cooktop in its seat.
2. Connect the four terminals A to the oven
terminals B situated in the rear section,
paying attention that the correspondance of
the coloured plugs is respected.
3. Fasten the cooktop.
4. Install the oven and fix it with the screws
supplied.
Note
If the cooktop must be connected to the separate
control panel instead of the oven read the
instructions supplied with the control panel.
ELECTRICAL CONNECTION
1gb59055.fm5 Page 11 Monday, November 11, 2002 6:54 PM