Operation Manual

DOOR REVERSIBILITY

For your convenience:

In case you want to stack the dryer on a washing machine,

you can reverse the door opening direction, to lower the

position of the door handle.

Unplug the dryer.

A. Open the door.

B. Using a spanner, turn the contact pin in the top part of the

door through 90° and pull it out.

C. Removing the door lock:

Unscrew the 2 screws above and below the door lock system.

D. Press the small knob above the door lock system with a small

screwdriver, move the door lock a little bit upwards and pull

the door lock towards you with your finger.

E. Reverse the door:

Remove the two screws of the door fixing plate.

Fasten the door again on the desired side with the 2 screws.

Take care to tighten the screws horizontally to avoid pinching

off the door.

Repositioning of the door lock:

Insert the door lock on the opposite side of the door fixing

plate.

Press it fully into the hole and move it downwards slightly,

until the small knob of the door lock system latches in

position.

Fasten the two screws above and below the door lock system.

Now re-insert the contact pin on the inside of the door, at the

top, by inserting it and turning it again through 90°.

NOTE:

Use a Torx T20 type screwdriver to undo and tighten the screws.