User manual
Table Of Contents
- Table of contents
- 1 General information
- 2 Safety instructions
- 3 Features
- 4 Installation
- 5 Starting up
- 6 Connections and controls
- 7 Operating
- 7.1 Starting the device
- 7.2 Operating on the unit
- 7.3 Menu overview
- 7.4 Functions in 1-channel DMX mode
- 7.5 Functions in 3-channel DMX mode
- 7.6 Functions in 4-channel DMX mode 1
- 7.7 Functions in 4-channel DMX mode 2
- 7.8 Functions in 6-channel DMX mode
- 7.9 Functions in 8-channel DMX mode
- 7.10 Functions in 10-channel DMX mode
- 7.11 Functions in 12-channel DMX mode
- 8 Technical specifications
- 9 Plug and connection assignment
- 10 Cleaning
- 11 Protecting the environment
In this menu, you can specify whether the display should be shown normally or rotated by
180°.
1. Press [MENU] repeatedly until the display shows ‘SET’ . Conrm with [ENTER].
2. Press [UP] or [DOWN] repeatedly until the display shows ‘DREV’ . Conrm with [ENTER].
3. Use [UP] or [DOWN] to select between ‘On’ (display rotated by 180 °) or ‘O’ (display not
rotated).
4. Press [ENTER] to accept the selection.
In this menu, you can set whether the display is automatically switched o or remains perma‐
nently on during operation.
1. Press [MENU] repeatedly until the display shows ‘SET’ . Conrm with [ENTER].
2. Press [UP] or [DOWN] repeatedly until the display shows ‘DBKL’ . Conrm with [ENTER].
3. Use [UP] or [DOWN] to select either ‘On’ (display permanently on) or ‘O’ (display turns
o after 30 seconds in case of inactivity).
4. Press [ENTER] to accept the selection.
Rotating the Display
Setting display illumination
Operating
2bright Blind FC LED IP
29
Blinder