User manual
Table Of Contents
- Table of contents
- 1 General information
- 2 Safety instructions
- 3 Features
- 4 Installation
- 5 Starting up
- 6 Connections and controls
- 7 Operating
- 7.1 Starting the device
- 7.2 Operating on the unit
- 7.3 Menu overview
- 7.4 Functions in 1-channel DMX mode
- 7.5 Functions in 3-channel DMX mode
- 7.6 Functions in 4-channel DMX mode 1
- 7.7 Functions in 4-channel DMX mode 2
- 7.8 Functions in 6-channel DMX mode
- 7.9 Functions in 8-channel DMX mode
- 7.10 Functions in 10-channel DMX mode
- 7.11 Functions in 12-channel DMX mode
- 8 Technical specifications
- 9 Plug and connection assignment
- 10 Cleaning
- 11 Protecting the environment
In this menu, you can specify the behaviour of the device when the DMX signal is interrupted.
1. Press [MENU] repeatedly until the display shows ‘SET’ . Conrm with [ENTER].
2. Press [UP] or [DOWN] repeatedly until the display shows ‘DFAL’ . Conrm with [ENTER].
3. Use [UP] or [DOWN] to select between ‘Hold’ and ‘BLAK’ to make the setting to be used
when the DMX controller fails.
Display Meaning
‘Hold’ Last DMX value is being held.
‘BLAK’ Spotlight turns o.
4. Press [ENTER] to accept the selection.
Behaviour on DMX control
failure
Operating
30
2bright Blind FC LED IP
Blinder