User Manual

ManualsBrandsiHealth Labs ManualsBlood Pressure MonitorsBlood Pressure Monitor

Fully Automatic iHealth Track Connected Arm Blood Pressure Monitor

USER MANUAL

Note: This is a shortened practical version of the user manual. For the full version of this

user manual, please visit www.ihealthlabs.eu/support

MEASURING BLOOD PRESSURE – A FEW BASICS

Blood Pressure Monitor that uses the oscillometric principle to measure your blood

pressure and pulse rate. Blood pressure fluctuates continually day and night. Any physical

activity or excitement will influence your blood pressure. Because of this, it is unusual to

obtain identical multiple blood pressure readings. This is why it is recommended that you

measure your blood pressure at approximately the same time every day.

1. Relax for 5 minutes before taking your blood pressure.

2. Sit comfortably at a table when measuring your blood pressure.

3. The cuff should be placed at the same level as your heart.

4. Do not talk or move during a measurement.

5. Use the same arm every time.

6. Remove the batteries from the device if it is not used for a month or more to avoid

battery leakage.

7. This blood pressure monitor is designed for adults and should not be used on children.

8. It is not recommended for people with serious arrhythmia to use this device.

9. Do not use any other cuff than the one supplied by iHealth.

10. Relax…

WHAT YOUR DEVICE SHOULD LOOK LIKE

The explanation of symbols on the display:

Bluetooth Symbol

Start/Stop button

Memory/Sync button

Summary of content (11 pages)

PAGE 1
Fully Automatic iHealth Track Connected Arm Blood Pressure Monitor USER MANUAL Note: This is a shortened practical version of the user manual. For the full version of this user manual, please visit www.ihealthlabs.eu/support MEASURING BLOOD PRESSURE – A FEW BASICS Blood Pressure Monitor that uses the oscillometric principle to measure your blood pressure and pulse rate. Blood pressure fluctuates continually day and night. Any physical activity or excitement will influence your blood pressure.
PAGE 2
Synchronization Symbol Release Air Symbol Memory Indicator Low Battery Indicator Irregular Heartbeat Symbol Blood Pressure Level Classification Indicator WHY YOU SHOULD CONNECT YOUR DEVICE Taking a measurement is easy. It’s what you do with the measurement that is important.
PAGE 3
a. Place the cuff tube downwards, around a bare arm about 2cm above the elbow joint. b. Sit with your feet flat on the floor without crossing your legs. While seated, place your palm upside in front of you on a flat surface such as a table.Lying Down During Measurement：（You can also lie on your back and place your left arm straight along your side with your hand palm-side up.） Position the air tube in the middle of your arm in line with your middle finger. c. Close the cuff with the Velcro fastener.
PAGE 4
c. If an Irregular Heartbeat (IHB) is detected during a measurement, the IHB symbol will be displayed (blinking). If an IHB is detected, the results of the blood pressure measurement may be inaccurate. Please consult your physician for an accurate assessment. d. At any time you can synchronize your device with the iHealth MyVitals App so that you can better manage your blood pressure. e. The monitor will automatically switch off after one minute to save the batteries.
PAGE 5
3. Press the “M” (Memory) button on the blood pressure monitor. The number of readings in the memory will be displayed. After a few seconds the iHeath Track Blood Pressure Monitor will automatically start synching the readings to the iHealth MyVitals App. While it is synchronizing you will see the readings numbers gradually come down on the blood pressure monitor, until they reach zero.
PAGE 6
9. GENERAL SAFETY AND PRECAUTIONS 1. Carefully read the user guide before operating the device. 2. Consult your physician for any of the following situations: a) The application of the cuff over a wound or inflamed area. b) The application of the cuff on the arm on the side of a mastectomy. c) Simultaneous use with other medical monitoring equipment on the same limb. d)The application of the cuff on any limb with intravascular access or therapy, or an arteriovenous (A-V) shunt.
PAGE 7
cleaners. 8. The supplier will make available on request the circuit diagrams, component part lists, descriptions, calibration instructions, or other information which will assist the user’s appropriately qualified technical personnel to repair those parts of equipment which are designated by the manufacturer as repairable. 9. It is recommended that if the cuff is used in a hospital or a clinic, it be disinfected twice a week.
PAGE 8
6V SN: 0197 R BLOOD PRESSURE MONITOR ANDON HealthAUTOMATIC Co.,Ltd NO. 31,Changjiang Road,Nankai District,Tianjin, P.R.China MODEL: Lotus KD-5907 Global Co.,Ltd EC REP 6V Symbol for "EUROPEAN 47 Spenlow HouseREPRESENTATIVE" Bermondsey London SE16 4SJ SN:Symbol for "SERIAL NUMBER" 0197 CE conformity mark ANDON Health Co.,Ltd NO. 31,Changjiang Road,Nankai District,Tianjin, P.R.China Lotus Global Co.
PAGE 9
Environmental humidity for storage: ≤85% Environmental pressure: 80～105kPa Battery life: Approximately 250 readings This blood pressure measurement system includes accessories: pump, valve, cuff, and sensor. Note: These specifications are subject to change without notice. This device bears the CE conformity mark. The quality of this wireless device has been verified and conforms to the provisions of the IEC 60601-1:2005 corr.1 (2006) + corr.
PAGE 10
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
PAGE 11
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following tow conditions: (1)this device may not cause interference, and(2) this device must accept any interference, includinginterference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d'Industrie Canada applicables auxappareils radio exempts de licence.