User's Manual

Setting the Clock

This unit has a Daylight Saving Time (DST) Switch located on the back of the cabinet. By

default, it is set to auto and will automatically adjust the time at the start and end of daylight

saving time. If your location does not observe daylight saving time or you wish to manually

adjust, move the switch to +1 to add an hour or to –1 to subtract an hour.

1. Press and hold the Time Set Button located on back of the unit for 2 seconds until the

clock display ﬂashes and a beep sounds.

2. Press the or Buttons to adjust the clock to the current time (hold for rapid setting).

Make sure you set the correct AM/PM time. The PM indicator appears to the left of the

display; there is no AM indicator.

3. Press the Time Set Button to conﬁrm the time. The year will ﬂash on the display.

4. Press the or Buttons to adjust the clock to the current year (hold for rapid setting).

5. Press the Time Set Button to conﬁrm the year. The month will ﬂash on the display.

6. Press the or Buttons to adjust the clock to the current month (hold for rapid

setting).

7. Press the Time Set Button to conﬁrm the month. The date will ﬂash on the display.

8. Press the or Buttons to adjust the clock to the current date (hold for rapid setting).

9. Press the Time Set Button to conﬁrm the date and exit clock setting mode. 2 beeps will

conﬁrm clock setting is complete.

TIP: To toggle the clock display between standard 12 hour time and 24 hour (“military”) time

display, press the Alarm Button or Alarm Button while the display is ﬂashing during

clock setting.

Setting and Using the Alarms

This unit features dual alarms which can be set to dierent times and alarm sources. Each is

set in the same way. Instructions are given as “Alarm Button”; use Alarm Button or

Alarm Button to set respective alarms.

Note: Each step must be completed while display is ﬂashing or step will time-out with any

changes saved.

Using the iBT232