iH20 IB in USB version Print color : Black text on white paper Size of manual: 178mmW x 178mmH March 5, 07 P1 ™ Model iH20 Water-Resistant Shower Speaker System For Your iPod® Questions? Visit www.ihomeaudio.
P2 Table of Contents Table of Contents Controls and Indicators iH20 Quick Start Using the iH20 in the Shower Using the iH20 Connecting iH20 to AC Power Source Playing and Charging your iPod Using the Line-In and Headphone Jacks Batteries Installation A Consumer Guide to Product Safety Trouble Shooting Solución De Problemas Warranty Information 1 2 3 4 4 4 5 5 6 7 8 9 Package Contents Congratulations on your iH20 home sound system for the iPod.
P3 Controls and Indicators Inside Left Side Panel Front Panel Raise Volume Line in Jack SPUL PU Reverse Button Forward Button Lower Volume Play / Pause Button (Hold 3 seconds for OFF) LED Light Side Panel (under rubber tab) Back Panel Loop Hanger Loop Hanger Release Latch Headphone Jack AC Adaptor Jack 1 Shower Rod Hook
P4 iH20 Quick Start 1:Opening and closing iH20 2:Power: AC or batteries OPEN RESET R ESET TEST T EST DC 7.5V LOCK To charge and play iPod, attach AC adaptor cable to jack on left of the iH20 (under rubber tab) and plug the other end into a working AC outlet. Does not charge batteries. For portable operation (in shower, etc.), open the battery door located inside the unit above the iPod dock. Install 4 AA batteries (match + and - polarity in diagram).
P5 Using the iH20 in the Shower The iH20 is only for shower use when operating on batteries. To avoid risk of electrical shock, never operate the unit near water when using the AC adaptor. a) The iH20 comes with both a shower rod hook and a looped hanger. a) For use in a shower (over shower head): • With speakers facing you, place Loop Hanger over shower head OR hang shower rod hook from shower head pipe and hang Loop Hanger from hook.
P6 Using the iH20 Connecting iH20 to AC Power Source RESET E R SET TEST E T ST a) Plug the AC adaptor cable into the AC Adaptor Jack on the left side of the unit and the other end into a standard 120 VAC wall socket. If an iPod is properly connected, it will begin charging, indicated by a flashing blue LED. The iH20 also operates on 4 “AA” batteries (see page 5 for information on installing/replacing batteries) for portable playing.
P7 Using the Line-in and Headphone Jacks a) An audio patch cord comes with the iH20. Use it to play nondocking iPod models or other audio devices through the iH20 Line-in Jack (one end in the device’s SPUL PU line out or headphones jack, the other in the iH20 line in jack). WARNING: Connector pins are for iPod ONLY. DO NOT attempt to connect any device other than an iPod to the connector socket in the dock. Use Line-in and audio cord instead.
P8 A Consumer Guide to Product Safety When used in the directed manner, this unit has been designed and manufactured to ensure your personal safety. However, improper use can result in potential electrical shock or fire hazards. Please read all safety and operating instructions carefully before installation and use, and keep these instructions handy for future reference. Take special note of all warnings listed in these instructions and on the unit. 1.
P9 Trouble Shooting Symptom Possible Problem Solution iH20 does not turn on no batteries are installed iH20 does not turn off improper shut down/ button not held long enough HOLD the Play/Pause button for 3 seconds to turn unit off No sound from iH20 Volume is set too low on iH20 Make sure volume is turned up headphones in headphone jack Make sure nothing is connected to the headphone jack iPod is not installed properly Make sure iPod is properly and securely connected (see below) iPod is not
P10 Solución De Problemas Posible Problema Síntoma Solución El iH20 no enciende No tiene pilas instaladas Instale pilas nuevas.
P11 Limited 90-Day Warranty Information iHome Products, a division of SDI Technologies Inc. (hereafter referred to as SDI Technologies), warrants this product to be free from defects in workmanship and materials, under normal use and conditions, for a period of 90 days from the date of original purchase. Should this product fail to function in a satisfactory manner, it is best to first return it to the store where it was originally purchased.