iP47 IB - USA version Print color : Black text on white paper Size of manual: 178mmW x 178mmH March 19,08 P1 Model iP47 Bluetooth Alarm Clock Radio for iPhone / iPod ® Questions? Visit www.ihomeaudio.
P2 Table of Contents Quick Start Controls and Indicators iP47 Display Using the iP47 Using the Alarms Listening to iPhone/iPod Listening to Radio Listening to other portable audio devices Listening to Bluetooth Music Making Calls with Bluetooth Mobile Phone Sleep Operation Dimmer Operation Remote Control Install Clock Backup Battery Replacing the Remote Control Battery A Consumer Guide to Product Safety Trouble Shooting Warranty 1-2 3 3 4 5 6 6 7 7 8 8 9 9 10 10 11 12-15 16 NOTE : The iP47 is designed fo
P3 FCC Information This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
P4 Quick Start 1: Power 2: Pair Your Bluetooth-enabled Phone With The iP47 A B RESET E R SET TEST 10:09 Connectivity Bluetooth Infrared Packet data Data transfer E T ST Select 10:09 On Off Back Select Back Attach AC adaptor cable to jack on back of the iP47 and plug the other end into a wall socket a) Select Bluetooth/discover mode on your phone (see your user manual) b) Press and hold the Play/Pause button on the iP47.
P5 Quick Start 7: Inserts 8:iPhone/iPod Insert an iPhone or iPod into the dock with proper insert (iPhone/iPod must not be in a skin or case). The iPhone/iPod will charge while docked. Press the Play/Pause Button on the iP47 to play your iPhone/iPod. Select the dock insert for your iPhone or iPod model from the table below and place insert in dock. Never dock your iPhone or iPod without an insert in place.
P6 Controls and Indicators Universal dock for iPhone/iPod Snooze/Dimmer Button Radio Preset Button Microphone Alarm 1 Button Sleep Button Alarm 2 Button Alarm On/Off Button Volume Up Up Button Volume Down Down / Set Button Mode Button (iPod, Bluetooth, FM1, FM2, AM or line in) iPod Alarm Reset/Power Button radio Play/Pause Button (for iPhone, iPod and Bluetooth music) End Button Talk Button Clear Button Ringer vol.
P7 Using the iP47 Connecting the iP47 to Power Source Connect the AC adaptor cable plug into the jack on the back of the system, then plug the AC cord of the AC adaptor into the wall outlet. Turning the iP47 ON or OFF Press the Button on the iP47 or on the remote control at any time to turn the iP47 On or Off. Note that a docked iPhone or iPod will continue to charge when the unit is turned off as long as the AC adaptor is plugged in. Setting Up the iP47 The iP47 clock is preset to U.S.
P8 Using the Alarms Setting the Alarms Alarm 1 (wake to iPhone/iPod or Bluetooth device) 1. Press and hold the Button until the hour display flashes. Press the or Button to set the alarm hour (hold for a few seconds to advance or reverse rapidly). Remember to set the correct AM or PM wake time. An icon in the upper right hand corner of the time display is the PM Indicator; there is no AM indicator. 2. Press the Button again. The minute display will flash.
P9 Listening to iPhone or iPod 1. Dock an already playing iPhone or iPod (always use proper insert, see table on page 2). The iP47 will automatically turn on and you will hear the audio playing from your iPhone/iPod. Note: If the audio source volume is too low on the iPhone/iPod, the iP47 may not detect that the iPhone/iPod is in play mode. If so, pressing the Alarm Reset/Power Button on the main unit once should make it play. 2.
P10 Listening to other portable audio devices You can play a MP3 player or other portable audio device through the iP47 via the Line in Jack. 1. Plug one end of an audio patch cord (available at http//:www.ihomeaudio.com) into the headphone or line-out jack on your device and the other end of the patch cord into the iP47 Line in Jack, located on the back of the unit. 2. Turn on the iP47 and press the Mode button until “Line in” appears in the lower part of display, indicating Line in playing mode. 3.
P11 Making Calls with a Bluetooth Mobile Phone Before you make a call with the iP47, you need to pair and link your Bluetooth-enabled phone with iP47. Please refer to Pairing procedure on page 7. Answer a Call: 1. To answer a call, press the Button. Now you can use the iP47 as a speaker phone. 2. Speak into the MIC (located below the Snooze/Dimmer Button) and press the or remote control to adjust the call volume. 3. To end the call, press the Button. Button on the iP47 or on the Dial/Re-dial Dialing: 1.
P12 Remote Control - Press POWER / alm reset to turn unit on or off and reset alarm to come on the next day. - Press MODE to select iPod, Bluetooth, FM1, FM2, AM or Line in mode. - Press PLAY/PAUSE to play iPhone/iPod/Bluetooth and to pause and to resume play. - Press VOLUME BUTTONS to adjust volume level. - Press FWD/REV to skip to next or previous track. Hold for high speed music scan. Press to scan the radio frequency manually. Hold for autoscan radio frequency.
P13 Install Clock Backup Battery The iP47 uses 3 x AA backup battery system to provide backup alarm operation and clock settings in the event of a power failure. If the Backup Battery has been installed and a power failure occurs or the AC cord is accidentally disconnected, the display backlight will not remain lit, but current time and alarm time settings will be temporarily maintained. Otherwise, you must reset the time and alarm settings. Replace Backup Battery 1.
P14 A Consumer Guide to Product Safety When used in the directed manner, this unit has been designed and manufactured to assure your personal safety. However, improper use can result in potential electrical shock or fire hazards. Please read all safety and operating instructions carefully before installation and use. Keep these instructions handy for future reference. Take special note, and adhere to all warnings on the unit and in the instruction and service manual. 1.
P15 Trouble Shooting Symptom Unit doesn’t respond (no power) Can’t play Bluetooth music from cellphone or other Bluetooth devices Possible Problem Solution AC adaptor isn’t plugged to a wall outlet or the connector is not plugged into the power supply jack on the back of the unit. Plug the AC adaptor into a wall outlet and plug the connector into the AC jack on the unit Wall outlet is not functioning Plug another device into the same wall outlet to confirm the outlet is working.
P16 Trouble Shooting Symptom Can't wake to Bluetooth music Calls don't sound clear Dialing out error message Possible Problem Solution Device is not in play mode Make sure your device is powered and streaming music Device is not charged Make sure your device is adequately charged to last through the set alarm time Device does not support A2DP and AVRCP Bluetooth profiles If your device does not support the A2DP and AVRCP profiles, set your alarm to wake to radio Volume on iP47 is too low Raise
P17 Solución De Problemas Síntoma Causa posible Solución La unidad no funciona El adaptador de AC no está conectado al Conecte el adaptador de AC a un tomacorriente y el (no circula corriente tomacorriente o el conector no está conectado conector a la ficha de salida AC de la unidad. eléctrica). a la ficha en la parte posterior de la unidad. No se escucha la música por el teléfono celular vía Bluetooth o desde otro aparato transmisor.
P18 Solución De Problemas Síntoma La música con Bluetooth no funciona como despertador. Las llamadas no se escuchan con claridad. Mensaje de error al discar Causa posible Solución El aparato no está en modo “Play” (reproducción). Asegúrese que el aparato esté conectado y transmitiendo música. El aparato está descargado. Asegúrese que el aparato tenga carga suficiente como para durarle hasta la hora programada. El aparato no soporta tecnología Bluetooth A2DP y AVRCP.
P19 Limited 90-Day Warranty Information iHome Products, a division of SDI Technologies Inc. (hereafter referred to as SDI Technologies), warrants this product to be free from defects in workmanship and materials, under normal use and conditions, for a period of 90 days from the date of original purchase. Should this product fail to function in a satisfactory manner, it is best to first return it to the store where it was originally purchased.
iP47 Quick connection sheet Print: PMS 293c and Black Size: 184mm W x 165.3mm H March 13,08. iP47 QUICK CONNECTION GUIDE for iP47 BEFORE YOU START Your Bluetooth device (cellphone, MP3 player, etc.) must support the HSP, HFP, A2DP and AVRCP Bluetooth profiles (commonly known as hands free and stereo audio profiles) to work with the iHome iP47.
